Firmware

Help,

Going away imminently, about to "sell" the HAH to HWMBO to turn light etc on and off while away, but the Google Calendar option is missing in version 251.  It's not on the web interface, I looked in the ini file, but no [googlecal] section, so I added it, as per the Wiki, rebooted....  Still not there.

Has anyone else noticed this?

Derek/Brett, if you can squeeze it into 252 I'll be happy to beta test, or have I just made a stupid mistake and not looked hard enough, I'll go and read through again just in-case.

Thanks

Karl

Hi Derek,

As you know I'm busy building my xAP remote control system for my Joggler.

I have now finally connected a CC monitor to my HAH, no problem.

When trying to get the level details to display on my Joggler I have come accross some issue with what is expected in the xAP message.  I don't fully understand all this but as far as I can tell and have been reliably informed, our xAP messages from the CC monitor aren't well formed.

Aparently the xAP spec says levels should be formatted so: level=value/max  eg level=944/10000

My upgrade went without a hitch.

I can confirm the RF modules > 4 do seem to work although this did work for me on 250 after ini config?

I do have 1 problem with the 5th home easy RF module that I've added.

When I throw it into my system, it works fine for about 10 secs, then turns itself off.

It then seems to disrupt all the other devices, i.e. It's label is rf5, if I turn it on, RF1 will turn on as well.  This is one example and other stuff will happen too.

Hi

I bought a livebox on ebay and it seems to work ok (I can login to the box using the browser in normal mode)

However, the repair utility times out every time. I have tried disabling the firewall and antivirus and disconecting the primary ethernet port from my main router, but with no success.

I get the three leds ok, and then the repair utility counts down, By the time it reaches zero, the leds have gone to a single flashing one and sometimes several leds flashing.

Hi, I'm trying to get access to the eeprom dump of microcontroller using this command:

microcom -s 115200 /dev/ttyS0

When I enter this, my system becomes unresponsive to keyboard and starts displaying all the 1wire outputs.
I can't even CTRL C, but have to close the session.

My plan was to add a few more RF sockets.
Any suggestions
Cheers
Gary

How excited was I.  Found your site via Automated Home, hunted down a Livebox, and then bricked it.  I was so excited, it's the first time I've tried something like this, but I missed one key part, I didn't unzip the reboot_blueg5.6-patched.gz file, and just copied that into /dev/mtd0.  I hope this is a warning to everyone else not to rush. 

Hi. I flash Livebox of Orange(spain)

I used for Telefonica ADSL and works, sincronice, etc....but when i opened a webpage, appears a page saying "there is a new firmware, please dont turn off the livebox"...then, the livebox start to actually to a new firmwareand blocked again for alone being used for orange...

Please, help ¡¡¡¡