General discussion

Description

Off piste conversations

Hi,

I have just flashed a LiveBox to the HAH firmware. Looks good so far. I've ordered a couple of JeeNodes to have a play with.

I'd also like to order a HAH parts bundle (and a JeeNode connection cable) however I see the Temperature Sensor jack plug appears to be out of stock - is there any way I can place an order for a bundle without the jack plug (and or sensor - i've already got a load already)?

Cheers, keep up the good work - I hope to be able to contribute to the forums once I have a working setup :-)

Andy

http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=270838036835

current cost sell them in lots of 3 but if you only want one i have 2 going spare (at less than cost price)

And the use i found for them to tell if you are feeding or drawing "off grid" /content/how-tell-if-generating-or-usin…

check out my other items i will be putting up some Current Cost Senseable Transmitter with a clamp for all you solar guys out there....have you seen the script?

price for these will be circa £15 for tx and clamp + £4 postage, current cost charge £25.99 just for the TX alone!! and £9ish for the clamp.

data cables cheapest bin on ebay 7.99+0.99p postage

large 25mm clamp cheapest bin on ebay

i post everything recorded.

 

For those of you that don't do ebay i will deal direct.

 

 

dean

Hi,

Before I go ahead and do somehing stupid I was wondering if someone with more electronics knowledge than myself could give me some advice on whether what I am about to do is sensible and not going to do any harm.

I want to get 1 wire devices into most of my rooms but cannot face the wiring task, I could do Jeenodes but for the number I want this would be costly.

Therefore I realised that I have already run a cat5 cable to my alarm box for bell monitoring and panic activation from the HAH. I therefore have enough free wires to get the 1-wire power,Gnd and data to my alarm box.

I want to put 1wire devices into my PIRs that are already located in good positions and disconnect their tamper wires and use them for power and Data. I will put a pull up resistor in each one to help with the cable length.

I am not bothered about loosing tamper protection.

However I am short of a ground wire but thought I could share this with the 12V gnd for the pir power lines as they are seperate systems.

Can anyone see any obvious problems with this. my electronics is getting better but still not great :)

thanks,

 

Garry

Hi, Is there anychance of having forum software that only allows sequential posts. At the moment it is rather confusing as posts can be mid-thread.

Not much of an issue, but thought I would ask.

Cheers

Dan

Currently possible countries one can order shop items to be delivered to are
Belgium, France, Germany, Ireland, Italy, Netherlands, Portugal, Spain, United Kingdom.

If there are users who live elsewhere - Scandinavia, Baltic States, US? - how have you done your ordering?  Not ordering?  Arranged via friends++?

Regards,

Aivo