For a few days now I’ve been monitoring my end of my ‘actual’ end of day FIT meter reading and the end of day PV Output reading so right now I don’t have a lot of data to work with however so far I’m seeing the actual FIT meter KW/h reading shows 10% to 23% more than my PV Solar output recorded on PV Output.
Member for
15 years 10 monthsPVoutput
In the rules you can adjust the output.
if(power < 40) power = 0;power *= 1.02;
1.02 means it increases my output by 2% to allow for currentcost inaccuracies
Member for
14 years 7 monthsYeah the thing is with mine
‘When power is greater than 1000W, increase by 10W, when power is greater than 1500W, decrease 10W, otherwise decrease it by 5%’
if(power > 1000) power += 10; else if(power > 1500) power -= 10; else power *= 0.95;
Just wondered if anyone else is suffering the big variances that I am?
Member for
15 years 1 monthVariation
I also have quite a big variation in the actual values and the ones reported by Current Cost in particular at low readings the CC significantly over-reads, so for instance when the inverter reads 10w the CC will read 150w. When I used my own script to post to PVoutput I put in some fairly large adjustments at low wattages to try and compensate.
Member for
14 years 7 monthsI must admit I've not done a
Using a rule in PVOutput like this…
if(power 50) power = 0; if(power > 2000) power += 20; else if(power > 1200) power += 15; else if(power > 600) power += 10; else if(power > 250) power -= 8; else power *= 0.91;
Might help however I’m going to somehow work out how to structure the rule, I’m not too sure how I’m going to work it out
Member for
16 years 5 monthsNot a Fiscal Meter
In CurrentCost's defence, they have never promoted their clamp based systems as fiscal meters, but as guides to typical endusers (ie not us) to enable them to manage their electricity use better
It may be that their Optismart meter reader is better beause it counts the pulses given out by your meter, but I have no personal experiences of using this sensor
kevinT