Hi Derek,
As you know I'm busy building my xAP remote control system for my Joggler.
I have now finally connected a CC monitor to my HAH, no problem.
When trying to get the level details to display on my Joggler I have come accross some issue with what is expected in the xAP message. I don't fully understand all this but as far as I can tell and have been reliably informed, our xAP messages from the CC monitor aren't well formed.
Aparently the xAP spec says levels should be formatted so: level=value/max eg level=944/10000
Member for
16 years 10 monthsSee BUG
See BUG http://code.google.com/p/livebox-hah/issues/detail?id=7
Member for
17 yearsTwo things
Hi Gary,
The Joggler piece is looking very good - we hope to put some HAH specific deatil on using the Joggler on the Wiki before too long.
As Brett points out, there is a known issue with the CurrentCost adaptor. I'm actually beta testing a HAH firmware version that fixes this - Brett will make the call as to when this release goes public.
Re your other point about the RF device status. The HAH keeps internal tracker variables to hold the state of each RF channel. So long as you don't reboot the HAH, these should report correctly. Could you possibly use xFX viewer to catch an example of where the HAH fails to report properly? Also, does the HAH web UI reflect this 'unknown' RF status (like when you press the 'Refresh' button on the UI)?
Cheers,
Derek
Member for
16 years 10 monthsSorry for the terse
Sorry for the terse response. I just started typing when SWMBO said it was time for dinner. build 252 will have a few things fixed in it:
Currently Derek is beta testing these changes to make sure things are ok. I've not got around to fixing the currentcost issue yet, its next on my list.
If you want to grab the BETA. Note: this will always overwrite your existing firmware - no version check is made, your /etc directory will be preserved but as with any update backup things you won't want to loose first just in case.
/etc_ro_fs/update-dev hah-beta.dbzoo.com
As I've just got settled in the US I've been a little behind in firmware fixes, hopefully once I get more establish I'll get some time for other improvements.
Brett
Member for
16 years 5 monthsRemaining issue to be confirmed
Hi Brett,
Have just downloaded the beta and installed. Tested the new additions and fixes and all seem OK.
One thing I notice is that there's still an issue with the graphs. I posted on this before. I have tested in both IE8 & FF 3.6.8.
I am unable to select a couple of the entries I have in my drop down. Essentially I see item 1 when I go to the page. If I select anything from the drop down, I get item 4 however if I press refresh repeatedly, it cycles through the 4 graphs? The CurrentCost graph is totally blank, not sure why...just off to look into that.
Any ideas?
Cheers
Gary
Member for
17 yearsGraphs are good for me
On IE8 and Chrome, with Build 251.8
Member for
16 years 10 monthsIf you have a large amount of
If you have a large amount of data and/or pachube is slow it will take a few seconds for all the data to transfer to your browser before the Javascript/Flash can turn it into a graph. When I get time I'll check this out althought I've never had and/or seen the issues are describing. Not to say they aren't happening to you of course. :)
When you say you downloaded the beta I'm now assuming you're on 251.8 ?