Selecting multiple RF units on GUI only first item is switched

Hi Brett,

I used to be able to select multiple RF items from the GUI and toggle them on/off and they would all switch as desired, however now only the first item in the list gets switched - I only noticed this after updating to the Mega328 and the Universal RF system.

David

Member for

16 years 10 months

brett

14 years 10 months ago

What was the Build/Firmware before the upgrade and the Build/Firmware after the upgrade.  This might help me answer where the problem is.  There is code in the HAH that is only enabled after certain AVR firmware version so the combination is important  This has been reported before but I'm powerless to reproduce, as in I have no ability to reproduce, not that I don't think its a real issue.

Brett

Member for

15 years 11 months

davidnewton

14 years 10 months ago

IIRC - Build/Firmware prior was 278/1.0 and after 302/3.4

David

Member for

16 years 10 months

brett

14 years 10 months ago

That's a HUGE jump - there is going to be a lot of changes between these revisions, right then so pretty much everything :)

Member for

15 years 11 months

davidnewton

14 years 10 months ago

If it would help I would be willing to downgrade back to the Mega8 and do incremental updates to narrow it down - if i were to do this 1. - preserving my current settings - best way of doing this - GUI backup? and 2. where to find the updates and how to go about loading them.

Thanks

David

Member for

16 years 10 months

brett

14 years 10 months ago

Pop the M8 chip back into the system and let me know if it starts working on not.  This will help a LOT.

Brett

Member for

15 years 7 months

garrydwilms

14 years 10 months ago

But have just tried it and can confirm it doesn't work on 298/3.4 either if that helps Cheers Garry

Member for

16 years 10 months

brett

14 years 10 months ago

Be interesting if the 2.x firmware has this issue... as that is URF but still in BASCOM.    Sounds more like some sort of xap-livebox process issue but I can't think of anything obvious.

Brett

Member for

15 years 11 months

davidnewton

14 years 10 months ago

First off correction to earlier post - HAH was on 300/3.4 not 302/3.4

Reinstated mega8 and updated RF strings for non URF setttings - RF now does not work (build 300/1.0) - xap-livebox-ini was still showing some of the URF codes so I removed them leaving just 2 of the older RF codes defined and rebooted via power cycle - still no joy - tried learning a power socket via on code but nothing - not sure what to try next?

David

Member for

16 years 10 months

brett

14 years 10 months ago

No problems - go back to AVR v3.4 and we'll work from there as that is the baseline where people need to be and any code fix would be against this version anyway.  Thanks for the troubleshooting hope it didn't put you out too much.

Brett

Member for

16 years 10 months

brett

14 years 10 months ago

I think I found the bug but so I don't make things worse I've check what I think is the fix in the BETA branch if somebody could verify that this is ok, I'll push this up as a new production build.

Brett

Member for

15 years 11 months

davidnewton

14 years 9 months ago

Hi,

Has anyone been able to test this beta code?

Thanks

David

Member for

15 years 11 months

davidnewton

14 years 9 months ago

Hi Karl,

Thanks for the feedback and for logging the issue.

David