Blank LCD

Given my lack of soldering skills I was quite surprised that I actually got my HAH LCD to work. Having said that, after a couple of hours it seems to go blank. Does anybody else have this problem or is it just (as I suspected) my poor quality work. If I switch off the box and restart it, it seems to come back on. Maybe it's a temperature thing as the LCD feels warm to the touch. Any one else have this?

Member for

17 years

derek

14 years 12 months ago

The LCD has no backlight, so should run completely cold. Perhaps a dodgy solder joint? Also, try turning the contrast potentiometer back and forth a few times, in case it's giving an intermittent contact.

Member for

14 years 11 months

af199

14 years 11 months ago

did you ever work out what the problem was here? I am currently having the same issue. Thanks. 

Member for

15 years 1 month

allanayr

14 years 11 months ago

I'm not entirely sure what the issue was but I believe that it was connected to the 1-wire connector. Since removing the 1-wire from my system the LCD has been completely stable. Perhaps the plug which connects the 1-wire to the board was touching the LCD contacts or something.

Allan