Given my lack of soldering skills I was quite surprised that I actually got my HAH LCD to work. Having said that, after a couple of hours it seems to go blank. Does anybody else have this problem or is it just (as I suspected) my poor quality work. If I switch off the box and restart it, it seems to come back on. Maybe it's a temperature thing as the LCD feels warm to the touch. Any one else have this?
Member for
17 yearsShouldn't get warm
The LCD has no backlight, so should run completely cold. Perhaps a dodgy solder joint? Also, try turning the contrast potentiometer back and forth a few times, in case it's giving an intermittent contact.
Member for
14 years 11 monthsdid you ever work out what
did you ever work out what the problem was here? I am currently having the same issue. Thanks.
Member for
15 years 1 monthNot very sure but...
I'm not entirely sure what the issue was but I believe that it was connected to the 1-wire connector. Since removing the 1-wire from my system the LCD has been completely stable. Perhaps the plug which connects the 1-wire to the board was touching the LCD contacts or something.
Allan
Member for
14 years 11 monthsOkay, thanks for the reply.
Okay, thanks for the reply. :)