Hi,
I've recently put together a HAH setup using a complete board from Derek (thanks for shipping this out). I'm nearly all working with the exception of the RF and the external 1-Wire.
Firstly, the header and cable shipped is a 4 way socket, not three as per the notes in the Wiki - Does anyone know if the 4 way header next to the 3 way header is also for 1-Wire? And if so, what is the pinout?
Member for
16 years 10 monthsThe lidl units won't work out of the box
You need to TRAIN the units using the right RF codes I'm pretty sure that they don't work out of the box. Derek knows more about this.
Check the schematic for wiring details: http://www.dbzoo.com/_media/livebox/pcb_rev1.jpg
Member for
17 yearsDon't confuse 1-wire with I2C
Not many folks use the I2C. I2C needs 4 wires. 1-wire needs 3. The four way connector on the PCB is for I2C.
If you want to hookup a DS18B20, you need to use the three way connector on the PCB. On the attach cable, just relocate one conductor - not too hard to do.
Derek.
Member for
15 yearsThanks Derek - i'll move the
Thanks Derek - i'll move the connector down and give it a go.
Regarding the RF - is there any way to test that its actually working? I understand the Lidl units (one I bought from the shop here) need to be trained by holding down the Teach-In button when sending the 'ON' code from the HAH - just not sure if the HAH is actually transmitting anthing...?
Andy
Member for
15 years 10 monthsget a meter check the small rf pcb for 12V-15V
without a scope or spectrum analyzer or 433.925MHz receiver thats about all you can do
Member for
17 yearsGotta be 12V at the module
Do check for 12V at the RF module. If you see more than this, something is wrong.
Also, when you say 'Lidl socket', do you mean the one from the HAH Shop /content/rf-mains-socket or some other type that Lidl have sold/are selling?
Derek