Receiving Current Cost transmissions via a Basenode

Reading over on the WH1080 Weather node thread got me thinking that it may be possible to receive and decode CurrentCost info and do away with the CurrentCost LCD which IMO is simply gathering dust via a jeenode with a 433mhz RFM12B module

The CC Transmitters operate on 433mhz FSK using RFM02 (similar to the RFM12B but Transmit only) and transmit at 6hz intervals depending on the number of sensors attached

I have been informed CC have not disclosed the format so it would need to be reversed engineered

Member for

14 years 5 months

mark_baldwin

13 years 9 months ago

I'm going to take a look over the next day so will keep you informed

Member for

14 years 7 months

paulsbiz

13 years 9 months ago

Check out Jack's code for the EDF Energy Monitor https://github.com/JackKelly It runs on a 433MHz Jeenode fine and reads Currentcost transmissions. Paul

Member for

13 years 11 months

AndrewJ

13 years 9 months ago

Hi Paul,

 

Thanks - was reading his blog before, noticed currentcost asked him to remove the project (the decoding code is still online however)

Member for

14 years 5 months

mark_baldwin

13 years 8 months ago

I've got this running on a basenode with 433 RFM12. I'm thinking of adding my WH1080 weather station decoder to this code and have an all in one unit.

I toyed with the idea of switching the RFM12 into OOK mode as documented on Jeelabs but instead I'm adding an AM 433MHz receiver to one of the analog ports instead.

Member for

14 years 5 months

mark_baldwin

13 years 2 months ago

I was going to try to have the WH decoder and CC decoder on one node but have now gone down the route of using two separate nodes. The WH receiver is running reliably as is the CC but still working on integrating this into the HAH. 

I've also got another node monitoring the HE Rf transmissions. It acts as confirmation that the HAH has sent an RF command but also picks up commands sent from the remotes, I'm planning on using that information to update the current state of RF sockets on the HAH i.e. if SWMBO turns on the kitchen TV with the remote rather than the HAH interface or app on the phone then I know ;)

There is now a small team working on integration, updates will hopefully follow soon

Member for

14 years 5 months

mark_baldwin

13 years 2 months ago

"I've also got another node monitoring the HE Rf transmissions. It acts as confirmation that the HAH has sent an RF command but also picks up commands sent from the remotes, I'm planning on using that information to update the current state of RF sockets on the HAH i.e. if SWMBO turns on the kitchen TV with the remote rather than the HAH interface or app on the phone then I know ;)"

 

Ah I see that is what the URF Rx tab is for :)

Good ol' Brett, 3 steps ahead


Member for

16 years 10 months

brett

13 years 2 months ago

Mark indeed this is what URF Rx is for http://www.dbzoo.com/livebox/universalrfrx you must be on the BETA release !

Since writing this up I've not had a good chance to really set this to work. I was hoping others might jump in and have play.  Certainly having an upgraded HAHCentral that can receive 433Mhz RF works really well and I did release a new sketch for this in source form so you could play.

Brett