1wire sensors reading 85

 

sensor 4 is reliable, 1/2/3 seems to go haywire, is this due to them being significantly different? sensor4 is brand new 1/2/3 are 12 months old

 

[1wire]
devices=4
timeout=30
temp_unit=C
sensor1.label=Feed To HWT
sensor2.label=Hot Water Tank
sensor3.label=Outside Temp

sensor4.label=HAH PCB/BOX

sensor1.romid=28AFC7F5020000AA28


sensor2.romid=2879E4F50200006A28
sensor3.romid=28CDCBF50200002628
sensor4.romid=281D529C0300000E

 

 

Member for

15 years 7 months

garrydwilms

14 years 8 months ago

Dean. If you google these one wire sensors you will find that 85 is the value reported when they have an error. I used to get the odd one or two of these before I changed my pull up resistors around a bit. Garry

Member for

16 years 5 months

BoxingOrange

14 years 8 months ago

Can you check your version, I think you might be using beta 304.2, try upgrading to beta 304.3, there may be a buffer overflow issue with the 1wire temperatures in 304.2.  If you're not using a beta, then DON'T upgrade.

Member for

16 years 5 months

kevin9

14 years 8 months ago

"85" is a special value sent and indicates a network error of some sort

I have two DS18B20s connected and working at the moment

Their ROMID's are

2883595B0100002C
281C2CAB02000093

Yours are

28AFC7F5020000AA28
2879E4F50200006A28
28CDCBF50200002628
281D529C0300000E

I have deliberately used a fixed width font to make it easier to see that 3 of yours seem to have longer ROMID's which is odd since all should be 64 bits. I think the leading 28 is indicates a DS1820 family device

I suggest you reset and reconfigure your 1-wire.

This worked for me ( although you could do it all by editting the ini file):-

On automation/Configure set 1wiredevices/number of sensors to 0

Reset the 1 wire bus

set number of devices to 4

reset the one wire bus

See how many devices you have and allocate them back into the sensor slots

HTH

Kevin

Member for

15 years 10 months

g7pkf

14 years 8 months ago

the odd one is a new one that came with the new hah pcb.

 

i may change them for all the same batch and see how i get on.

 

thanks for the pointers on 85, and no not on beta at present, testing a totally new box (with old 1 wire's)

Member for

16 years 10 months

brett

14 years 8 months ago

This trailing 28 was a bug in the 2.x AVR firmware.

Its fixed in later 3.x firmware revision and ignored in the HAH code that interprets these ROMID to make sure 2.x firmware works as it should.  You should be able to remove those digits without any ill effects.

Brett

Member for

15 years 10 months

g7pkf

14 years 8 months ago

A poor ground wire was causing all the problems :)