Livebox

The Livebox unit + the HAH addon board is a fine way to deliver a number of 'remote control' capabilities. However, if you just need a small/very low power unit that will connect directly to a CAT5 feed and drive a couple of relays ... the Dbzoo EtherRelay unit is the thing.

The Livebox case is held together by four torx T10 screws. Some boxes have these nipped up pretty tightly and it can be awkward to find an ordinary screwdriver that will fit. 

Note that you aren't buying this screwdriver, just borrowing it. Post it back to us once you have got your Livebox opened up. Only available for sending out with a Livebox from the shop.

Serial console cable for the Livebox. Great to help with initial firmware replacement on the Livebox. Also handy if you wish to use the Livebox as an embedded Linux platform. Comes with a Cisco RJ45 to DB9 cable and a MMJ to RJ11 to hookup to the Livebox. Supplied pre-built and tested.

Just plug in the MMJ plug into the connector on your Livebox & set your terminal emulator to run at 115200 baud.

If you don't want to buy your own Livebox & reflash it, we can supply a 'ready to go' reflashed Livebox including the LCD aperture and mounting holes ready milled. You get the reflashed Livebox and a PSU. If you need other hardware addons, these are available elsewhere in this shop. N.B. Due to demand, leadtime on this item is currently 2 weeks.

If you don't want to buy your own Livebox & reflash it, we can supply a 'ready to go' reflashed Livebox. Branded with the Wanadoo logo. Comes complete with a PSU. Easy to get started, just connect this to your router with your Cat5 Ethernet cable and power-up. You get the reflashed Livebox and a PSU. If you need other hardware addons, these are available elsewhere in this shop. N.B. Due to demand (and a severe lack of spare time), leadtime on this item is generally 2 weeks.

You send one half of your Livebox case to us. We mill the necessary aperture for the LCD. We then send the milled case back to you

Serial console cable for the Livebox. Great to help with initial firmware replacement on the Livebox. Also handy if you wish to use the Livebox as an embedded Linux platform. Comes with a Cisco RJ45 to Db9 cable and a MMJ to RJ11 to hookup to the Livebox. Supplied as a kit of parts for you to solder up (the RJ11 to MMJ cable is pre-built).

Just plug in the MMJ plug into the connector on your Livebox & set your terminal emulator to run at 115200 baud.