Home Automation

Pillars and screws to mount your PCB inside your Livebox

PCB pins, cable with Molex header and panel mounting 3.5mm jack socket. All ready for you to solder up (as per instructions on the Wiki).

A temperature sensor (DS18b20) ready for mounting in a 3.5mm jack plug. Jack plug and DS18b20 supplied for you to solder up.

Fit to PCB. The two way connector allows one switch input to be attached. Up to 4 input connectors can be populated on the PCB.

Fits to the HAH PCB. One relay + protection diode, driver transistor, resistor and terminal connector blocks included. A maximum of four relays can be fitted to the PCB

Microcontroller (Atmel MEGA328P) pre-programmed to operate with the HAH firmware. DIL socket, crystal and caps included. This chip includes support for the new Universal RF capability.

The PCB that holds the HAH microcontroller. Supplied with header pins and resistors for the 1-Wire and I2C bus. A good option if you want to try programming your own microcontroller.